- Does the TYGR 300 R work with PS5/XBOX Series X?

Yes, the TYGR 300 R works with the PS5 and the XBOX Series X. You can use the jack on the controller for this. Keep in mind that the TYGR 300 R is a passive headphone and the maximum volume depends on the performance of the built-in sound card. Therefore, different maximum volumes can occur depending on which platform you play on. With the PS5 controller, it is noticeable that normal jack plugs are slightly looser than usual. This can be observed in a wide variety of products with standard plugs. The result is that the plug can slip out a bit, which can lead to a disconnection of the microphone connection.

+ How does the TYGR 300 R differ from the DT 880 PRO and DT 990 PRO?

The DT 880 PRO has a very linear frequency response, while the DT 990 PRO has a slightly more accentuated bass and accordingly more present trebles for a pleasant balance. Both are primarily designed for studio applications. The TYGR 300 R focuses on gaming and is based on the frequency response of the DT 990 PRO. A powerful bass and detailed accentuated treble go very well with gaming. However, the sound design of the DT 990 PRO has been further optimized for gaming, sometimes through the use of a special acoustic fleece.

+What is the difference between TYGR 300 R and MMX 300?

The MMX 300 and the TYGR 300 R both have a system with 32 ohms impedance. However, the TYGR 300 R has an open design which results in a better three-dimensionality of sound and a higher wearing comfort due to less heat generation. The slightly lower contact pressure also contributes to a more comfortable fit. In terms of material quality, both are on a par. The TYGR 300 R, however, uses a specially developed acoustic fleece, which provides better sound reproduction in the treble compared to the MMX 300. In general, if ambient noise is not a problem and you don't necessarily want a headset, we would recommend TEAM TYGR for optimal sound reproduction and recording.

+Can I mount the microphone on a regular stand?

Yes. Simply unscrew the screw under the desktop stand (you can use a screwdriver or a coin) and mount it on a 3/8” thread with the still attached hinge (stand adaptor). For US threads please use an 3/8"" to 5/8” adapter.